Knowledgebase: General
Configuring the pre-rbs.bat and post-rbs.bat to only run on a particular backup set

You can configure the batch files per backup set. You can create custom batch files per backup set with filenames in the format of:

pre-{backupset name}.bat
post-{backupset name}.bat

For example, if the backup set name is "Blank" then, create batch files and name them as: "pre-Blank.bat" and "post-Blank.bat"

Then, these batch files are only executed if the backup set "Blank" runs.

 

(289 vote(s))
This article was helpful
This article was not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
Online Backup Software by Remote Backup Systems fusion