Knowledgebase: RBS Server
Datacon: Error: 10057 Server is unable to connect to client

The following messages can show up in the Server's log files:

Error (10054) The virtual circuit was reset by the remote side executing a "hard" or "abortive" close. This normally results if the peer application on the remote host is suddenly stopped, the host is rebooted, or the remote host used a "hard close". This error may also result if a connection was broken due to "keep-alive" activity detecting a failure.

Error (10053) An established connection was aborted by the software in your host machine, possibly due to a data transmission timeout or protocol error. PowerTcp will close the connection when this error is encountered.

DATACONN: Error: 10057 Server is Unable to Connect to Client, Connection interrupted or Aborted, or Client should switch to Passive mode (DataConn.State)

1/7/2004 00:01:11 : 0 : 8.4.89 : Error: (0): at DataConn.State

All of these issues can be caused when another server is running on the same computer, using the same port number as the RBS Server. If your RBS Server is set to port 21, look for an FTP server.

The assigned port number for the RBS Server is 2774. 

 

(292 vote(s))
This article was helpful
This article was not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
Online Backup Software by Remote Backup Systems fusion